The install file for NanoCAD can be found in the PreRequisites install file or you can contact the Helpdesk Team and they can email you a download link.
The following instructions will walk you through installing from the standalone NanoCAD install file on your desktop.
After the NanoCAD install file is downloaded from the ShareFile link follow the steps listed below:
1.) RMB click on the install file from your desktop to select Open With\Windows Explorer.
2.) Select the file titled: NCITW20.0(5366.0169.5466)-Alpine-2-3-22 to open.
3.) Once open you will want to double click the setup.exe file to begin the install. *If prompted by your Antivirus or Firewall, just select yes*
4.) After you have begun the install this dialog box shown below will appear.
5.) After Click Next, you will need to check the box beside I accept the terms in the License Agreement. Click Next.
6.) You will then receive a prompt for the Destination Folder. Click Next.
7.)A dialog of the File Extensions will then appear. Click Next.
8.) After selecting Install, the install will begin.
9.) You will see the following dialog. It will continue to run until the green bar is complete. Click Next.
10.) After selecting Finish, you will have successfully installed NanoCAD 20.0
11.) You will have a new icon on your Desktop titled nanoCAD ITW that looks like this.
12.) You may double left click the icon to now open NanoCAD.
Please reach out if any further assistance is required.
Helpdesk: 866.237.2878
Email Support: helpdesk@alpineitw.com