If you open your layouts and discover that their are no trusses in the Trusslist but you can clearly see all of your trusses have engineering, you may need to reset the parameters of the Trusslist window.
To do this first exit iModel.
Open your File Explorer window.
Browse to your install location to the Usr01 folder.
Open your User.ini in note pad.
Go to Edit\Find and type in trusslist:
Look for the following block of information:
[trusslistdefaults]
3ColumnWidth = 44
0ColumnWidth = 98
4ColumnWidth = 36
SortColumn = -1
1ColumnWidth = 36
ColumnOrder = 01234
Ascending = 1
2ColumnWidth = 36
Then change the 6 “ColumnWidth” lines to a value greater than 0 or match the numbers above.
Go to File and Save the change.
Now relaunch the software and the trusses should now be visible again in the Trusslist:
Please reach out if any further assistance is required.
Helpdesk: 866.237.2878
Email Support: helpdesk@alpineitw.com