The connector label may display a special character to indicate additional information. A few commonly seen characters are listed below:
(R) A label showing an (R) indicates that the plate is rotated 90 degrees to the typical location.
(**) A label showing (**) indicates that the connector requires special positioning.
(I) A label showing an (I) indicates that the plates were sized using 0 percent Fabrication Tolerances, 0 degrees Rotational Tolerance and/or zero Positioning Tolerance.
(OL) A label showing an (OL) indicates that two plates are overlapping on the joint.
Please reach out if any further assistance is required.
Helpdesk: 866.237.2878
Email Support: helpdesk@alpineitw.com