Question:
Where are the Splice settings set?
Answer:
The splice settings are set under the Very Top Plate Settings in the Fabrication Files. See below.
“The two things that we are searching for right off the bat are where to locate the 2 options in the attached images;
- In the Editing VisionREZ roof style tool under the Eave Trim tab there is a variable D for the location of the bottom of the soffit. Where do we change that variable?
- In the Wall Framer under Panel Break – Review there seems to be an arbitrary offset which prevents the splicing of top &/or bottom plates at the studs. How do we adjust this offset?
Once again thank you in advance.
There is no variable “D” in the Eave Trim Tab in either 2018.3 or 2019:
The bottom of soffit is dependent upon the rafter tail height.
