If you are printing Plate Plot details and not all joints are plotting you will want to check your JSI setting in Job Settings.
Go to Job Settings\Engineering Output tab and to the "For Joints with JSI>"field.
This field enables you to control the specific plated joints you want to be included in the plate plot output.
The default setting is zero, which means any joint JSI>=zero is shown on the output.
If you only want to display plated joints with a JSI>= 0.80, for example, then enter 0.80 into the input field.
If you want to see all joints make sure you have this setting set to zero.
Please reach out if any further assistance is required.
Helpdesk: 866.237.2878
Email Support: helpdesk@alpineitw.com
www.alpineitw.com
www.alpineacademyitw.com